Internal radio – Spectra Precision ProFlex 800 Reference Manual User Manual
Page 66
52
Using the Web Server
listed below and described one after the other in the next
sections:
–
Internal radio
– Direct IP via modem
– Direct IP via Ethernet
– NTRIP client via Ethernet
– RTK corrections received on port A, B or F
– Rover operating in Flying RTK mode.
– Rover operating in Hot Standby RTK.
Internal Radio
• Unless already done, please follow all the steps described
in section General Parameters on page 49 before
proceeding with the steps below.
• Still on the
Rover Setup page, read the content of the
Internal Radio Port D pane. Normally, the content of the
read-only
Connection field has been updated when opening
the
Rover Setup page to report the type of internal radio
module currently used by the receiver (ADL Foundation).
Just check that this field reads the name of the expected
type of radio.
• Click on the
Power On option to ask for radio power-up.
• At the bottom of the page, in the
Differential Port pane,
select the
Automatic option to let the receiver detect the
incoming differential stream automatically.
NOTE:
Automatic is the recommended choice for the
Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.
• Click on the
Configure button to let the Web Server load all
your new parameters to the receiver. As a result, the radio
module is powered up.
Internal
Radio
ProFlex 800
RTK Corrections
(UHF radio link)
Base
Radio