Spectra Precision ProFlex 800 Reference Manual - Manual (Page 476)

462
Set Command Library
Comments
• When two RINEX files are created with different periods,
character “p” or “P” should be used so the receiver can
store the two types of RINEX files in different directories.
If the subdirectory format is “s/Y/D/p” then the files
logged at 1 second recording interval, on site “CARQ”, on
Feb 1, 2012 (day 32) will be pushed to the folder named
“…/CARQ/2012/32/data_1” and the files logged at 30
seconds will be moved to the folder “…/CARQ/2012/32/
data_30”.
• Data files will be uploaded automatically to the FTP server
only if the $PASHS,SES,PAR command allows it
(“Automatic FTP transfer” must be enabled).
• When data transfer to the FTP server is requested and the
receiver fails to perform that transfer, a new attempt is
made after 30 seconds of idle time.
If the transfer fails again, the parameters describing the
failed transfer request (file name and path, queried FTP
server, FTP login and password) are saved to a rescue file.
If a backup FTP server has been defined, the receiver will
then try to transfer the same file to the backup FTP server.
In case of failure, the receiver will try again after an idle
time of 30 seconds. If it fails again, and as previously, the
parameters describing the failed transfer request (file
name and path, queried FTP server, FTP login and
password) will be saved to the same rescue file, adding up
to the previous failed request.
Every two minutes, the receiver routinely opens the rescue
file (if there is one) and analyzes the older failed transfer
request. If that request refers to a file that is no longer in
memory (internal or USB) or is older than two days, then
the receiver will ignore that request and remove it from the
rescue file. If on the contrary, the file is still there and
created less than two days ago, the receiver will make a
new attempt to transfer the file (in the same conditions as
originally (i.e to the same FTP). If the transfer succeeds,
the corresponding request will then be removed from the
rescue file.
Example
Defining a primary FTP server and a backup FTP server:
$PASHS,SES,FTP,PAR,ADD,MyPrimaryFTP.com,PRT,21,LGN,Myusernam
e,PWD,Mypassword,PTH,/Myfolder,SUB,Y/D/s,IPP,P,BKP,1,AD2,
MybackupFTP.com,PR2,21,LG2,Myusername2,PW2,Mypassword2,
PT2,/Myfolder*6871