Spectra Precision ProFlex 800 Reference Manual - Manual (Page 532)

518
Query Command Library
BEEP: Beeper State
Function This command is used to read the current state of the internal
beeper.
Command Format Syntax
$PASHQ,BEEP[*cc]
Response Format Syntax
$PASHR,BEEP,s1,d2*cc
Parameters
Example $PASHQ,BEEP
$PASHR,BEEP,OFF*05
Relevant Set
Command
$PASHS,BEEP
BRD: RTC Bridge
Function This command allows you to list the current settings of the
RTC Bridge function.
Command Format Syntax
$PASHQ,BRD[*cc]
Response format Syntax
$PASHR,BRD,s1,d2,c3,c4*cc
Parameter Description Range
s1 Beeper enabled (ON) or disabled (OFF) ON, OFF
d2
Timeout, in seconds:
• =0: No timeout
• >0: Buzzer will go out after thespecified timeout
if the alarm has not been acknowledged at the
end of that time.
0-99
*cc Checksum *00-*FF