Spectra Precision ProFlex 800 Reference Manual - Manual (Page 329)

315
Set Command Library
ANP,PCO & ANP,EDx: Creating/Editing Antenna Definitions
Function These commands allow you to create or modify antenna
definitions. The definition of an antenna includes a name for
the antenna, all its phase center offsets as well as the
elevation-dependent delays (in 5-degree steps).
Command Format Syntax
$PASHS,ANP,PCO,s1,f2,f3,f4,f5,f6,f7[*cc]
$PASHS,ANP,ED1,s1,f2,f3,f4,f5,f6,f7,f8,f9,f10,... ,f19,f20[*cc]
$PASHS,ANP,ED2,s1,f2,f3,f4,f5,f6,f7,f8,f9,f10,... ,f19,f20[*cc]
Parameters
ANP,PCO (PCO for Phase Center Offsets)
ANP,EDx (EDx for L1 and L2 Elevation Dependent delays)
Examples
Setting the PCO parameters for antenna ASH8987:
$PASHS,ANP,PCO,ASH8987,0,0,110,0,0,128*29
Setting the L1 delays for antenna MYANTENNA:
$PASHS,ANP,ED1,MYANTENNA,0,-2,0,-1.5,1,1.2,0,0,0,0,1,1,-1,0,1.2,
-1.2,0,1,0*49
Parameter Description Range
s1 Antenna name
31 charac-
ters max.
f2 L1 phase center offset, in mm, in the North direction ±0-1000.0
f3 L1 phase center offset, in mm, in the East direction ±0-1000.0
f4 L1 phase center offset, in mm, in the vertical direction ±0-1000.0
f5 L2 phase center offset, in mm, in the North direction ±0-1000.0
f6 L2 phase center offset, in mm, in the East direction ±0-1000.0
f7
L2 phase center offset, in mm, in the vertical (up)
direction
±0-1000.0
*cc Optional checksum *00-*FF
Parameter Description Range
s1 Antenna name
31 charac-
ters max.
f2-f20
Elevation-dependant delays, in mm, for elevations
from 90 to 0 degrees, in 5-degree steps.
±0-1000.0
*cc Optional checksum *00-*FF