Spectra Precision ProFlex 800 Reference Manual - Manual (Page 275)

261
Integrating ProFlex 800 into Your Application
• Make room for the receiver, allowing for enough space at
the rear and at the front of the receiver to accommodate
the receiver itself and the cables connected to it, and also
the Bluetooth and cellular antennas if used.
If the internal battery is used (recommended for backup
DC source in case of power outage), allow for enough
space near the trapdoor so it can be easily opened to insert
or remove the battery.
To sum up, you should allow for a cubic space adjacent to
the fixing plane with the following approximate
dimensions (H x W x D) (see also diagram below): 186 x
215 x 370 mm (7.4 x 8.5 x 14.6 “)
This should also be an open space allowing sufficient
ventilation. Air should freely circulate around the receiver.
• Consider the following to orientate the receiver on its
support: Do you need visual access to the display screen?
Do you need frequent access to the USB port? Are you
using the front panel buttons frequently? Do you often
need to connect or disconnect cables to/from the rear
panel? Will a Bluetooth connection be used between the
receiver and the user interface?
+ 90 mm
200 mm
+ 80 mm
100 mm
100 mm
215 mm
76
mm
+ 110 mm