Spectra Precision ProFlex 800 Reference Manual - Manual (Page 147)

133
Web Server Help Files Collection
Embedded NTRIP Caster via port P (Ethernet)
Network 2
Use this area to declare the type of connection used by the
base to distribute its data through the Internet (network 2).
See the description of each parameter in the table below.
Address IP address of the NTRIP caster NTR,PAR
Port IP port number of the NTRIP caster NTR,PAR
Mount Point Mount point used to connect to the NTRIP caster NTR,MTP
Password Password required to send data to the NTRIP caster NTR,PAR
Parameter Designation $PASHS
Connect
Now
Check this button to let the receiver perform the
requested network connection after you have clicked
on the Configure button.
-
Address
A read-only field reading ”localhost”, invoking the IP
address of the receiver itself.
-
Port
A read-only field indicating the IP port of the NTRIP
caster, as defined on the NTRIP caster settings page.
-
Mount Point
Choose one of the mount points declared in the
embedded NTRIP caster through which the data will
be made available to caster users.
NTR,MTP
Password
A read-only field indicating the password of the NTRIP
caster, as defined on the NTRIP caster settings page.
Parameter Designation $PASHS
Connection
Choose the type of network connection used in the
receiver:
• None: No network connection used.
• Ethernet Direct IP - port Q: The base is connected
to the Internet through its Ethernet port.
• Ethernet NTRIP Server - port Q: The base is con-
nected to the Internet through its Ethernet port
using an IP connection to send its data to an NTRIP
caster. (The base is then a “client”.)
• Embedded NTRIP Caster - Port Q: (Available only if
the NTRIP caster option is installed): The base
delivers its data to the embedded NTRIP caster via
port Q.
MDM,..
NTR,PAR
DIP
Parameter Designation $PASHS