Direct ip via ethernet – Spectra Precision ProFlex 800 Reference Manual User Manual
Page 91
77
Using the Web Server
–
Access Point: Enter the URL of the mobile
communication provider.
–
Access Point Login: Enter the login of the mobile
communication provider.
–
Password: Enter the password of the mobile
communication provider.
• Click on the
Configure button.
• Now please follow all the steps described in section
68 and then proceed with
the steps below.
• Still on the
Base Setup page, make sure the Connection
fields in the
Serial Port x panes are all set to “None/Cable”
• In the
Network 1 pane, choose “Modem Direct IP - Port E”
in the
Connection field.
• The base being necessarily a client, enter the information
(
Connect Now, Address, Port) allowing it to connect to the
rover (the server) to which it is supposed to deliver
corrections. No
Login or Password is needed in this case.
Enable
Connect Now to allow the receiver to establish the
connection right after you have clicked on
Configure.
• In the
Differential Stream 1 pane, choose Port= “E - Modem”
as the output port delivering the generated differential
data. In the
Message field, choose the type of differential
message provided through this port (ATOM, RTCM, CMR,
CMR+ or DBEN).
NOTE: The receiver has been designed to offer two
separate and independent differential data outputs. Each
one can output a specific type of differential message. If
only one output is used, select
Port=“None” for the other
output.
• Click on the
Configure button to let the Web Server load all
your new parameters to the receiver. You have now
reached the end of the configuration phase.
Direct IP Via
Ethernet
ProFlex 800
RTK Corrections
Ethernet
Users
IP address
or server name
Internet
(Client)