Spectra Precision ProFlex 800 Reference Manual - Manual (Page 379)

365
Set Command Library
Parameters
Examples
Establishing the programmed Direct IP connection:
$PASHS,DIP,ON*05
Relevant Query
Command
$PASHQ,MDM
See also $PASHS,DIP
$PASHS,DIP,PAR
$PASHS,DIP,OFF
DIP,PAR: Setting Direct IP Parameters
Function This command is used to set the different parameters
allowing the receiver to perform a Direct IP connection to an
external server, typically a base.
Command Format Syntax
$PASHS,DIP,PAR,ADD,s1,PRT,d2[,LGN,s3,PWD,s4][,IPP,c5][*cc]
Parameter Description Range
c1
IP port used for the connection to the server:
• E: Internal modem
• P: Ethernet stream 1
• Q: Ethernet stream 2
When c1 is omitted, the concerned port is
the one specified in the last $PASHS,DIP,
PAR or $PASHS,DIP command run.
E, P, Q
*cc Optional checksum *00-*FF