ETC Congo Family v6.4.0 - Manual (Page 1000)

998
Receive - OSC Input (6.3)
To receive OSC commands you have to activate reception of OSC and select the
appropriate Port number (default 7000) in
Play Settings - Show Control .
The device transmitting OSC needs both this port number and the IP address of your Congo
system. You can check your IP address in Browser >About >About Congo.
About OSC commands
• An OSC command consists of an address, sometimes followed by a value and/or an
argument, eg "/masters/page/X"
• Buttons may be momentary. eg "/mainplayback/go".
• Buttons may be On/Off, use 0.0 for Off, 1.0 for On. eg "/masters/flash/X 0.0"
• Fader and Attribute values are 0.0 to 1.0 (float) for minimum and maximum. eg
"/masters/fader/1 0.5" to set Master 1 to 50%"
The following commands are supported:
Refresh
/refreshstatus = Command to force an update of all labels and fader values
Masters
/masters/fader/X <0.0-1.0>
/masters/key/X <0.0-1.0>
/masters/flash/X <0.0-1.0>
/masters/pagePlus/X = Page+ for master block X (1-4)
/masters/pageMinus/X = Page- for master block X (1-4)
/masters/page/X = Master page (1-999)
Transmit:
/masters/fader/X <0.0-1.0> = transmission when a fader value changes
/masters/label/X <string> = Sends master label changes
/masters/page/label/X <string> =Sends master page label changes
Main Playback
/mainplayback/go
/mainplayback/pause
/mainplayback/goback
/mainplayback/seq+
/mainplayback/seq-
/mainplayback/refresh
Effects
/effects/bpm/X
/effects/tap/X
Direct parameter control
/parameter/pan <0.0-1.0>
/parameter/tilt <0.0-1.0>
/parameter/hue <0.0-1.0>
/parameter/saturation <0.0-1.0>
/parameter/intensity <0.0-1.0>