ETC Congo Family v6.4.0 - Manual (Page 301)

299
Output Editor - Dimmer Check Mode
Dimmer Check mode is a fast way to check the outputs consecutively.
1. Select first output with # OUTPUT
2. Set a level for checking with # @ LEVEL (a level is given between 0-255. 128 = 50%)
3. Press + or - to use this level and step to the next/previous Output. Levels that are higher
than zero are restored automatically as they are passed by.
4. Deselect the last output to leave channel check mode (0 OUTPUT). Or, simply set that
output to a level of 0% (0 @ LEVEL or use the wheel)
Output Editor - Channel Check Mode (6.1)
Channel Check mode is a fast way to check the channels consecutively in the output editor.
1. Select first output with # CH
2. Set a level for checking with # @ LEVEL (a level is given between 0-255. 128 = 50%)
3. Press + or - to use this level and step to the next/previous patched channel. Levels that
are higher than zero are restored automatically as they are passed by. Channels that are not
patched will not be lit.
4. Deselect the last channel to leave channel check mode (0 CH or C/ALT CH). Or, simply
set that channel to a level of 0% (0 @ LEVEL or use the wheel)