ETC Congo Family v6.4.0 - Manual (Page 271)

269
Dock Areas - Functions
The dock areas are easy to use once they are configured. Two dock areas are set up
default, the left (browser) and the bottom (effects) on screen 1.
You can toggle the contents of any selected dock area by holding BROWSER and pressing
FORMAT.
Configure Dock Areas (6.3)
A dock area has to be configured before you can use it.
< dock configure>
• SETUP & BROWSER
• Right-click on the background at the edge where the dock will reside. (6.3)
• From the Browser >General Settings >Dock Areas (MODIFY)
SETUP & BROWSER
Configure new dock areas for the currently focused screen by holding SETUP and pressing
BROWSER.
NOTE
Docks are defined for each display on the Congo - so each monitor
can support 4 docks. To configure docks, first select a tab on the
screen you want to assign docks to, then press SETUP & BROWSER
to open the setup dialog.
It is possible to configure any type of area several times.
In Congo Sr it is not possible to open docks on the right side of
screen 1.