ETC Congo Family v6.4.0 - Manual (Page 463)

461
Capturing levels or parameters
Regardless if Capture mode is active or not, it is always possible to capture channels or part
of channels. Capture mode is not toggled to a permanent active state by these commands
(5.0).
OBSERVE
That all of these commands will affect the currently selected channels. If a number is entered
first, only this channel will be affected.
Action Key Feedback
Intensity and
parameters [CAPTURE] & [CH] Captured channels will have
a red background for the
channel number.
Intensities [CAPTURE] &
[@LEVEL] Level is captured until
released.
Parameters [CAPTURE] &
[ATTRIB] Parameters are captured
until released.
Single Parameters [CAPTURE] &
[Wheel_key] Parameters are captured
until released.
Focus parameters [CAPTURE] &
[FOCUS] Parameters are captured
until released.
Color parameters [CAPTURE] &
[COLOR] Parameters are captured
until released.
Beam parameters [CAPTURE] &
[BEAM] Parameters are captured
until released.
U1-U3 parameters [CAPTURE] & [U1-
U3] Parameters are captured
until released.
Recording only Captured channels
You can record only captured channels.
Action Key Feedback
Record captured [RECORD] & [CAPTURE] Levels and parameters of
only captured channels are
recorded.