ETC Congo Family v6.4.0 - Manual (Page 458)

456
Set Channel Levels
Once a channel(s) is selected you can set levels in the following ways.
Level Command RPN AT MODE
Set to 50% [5] [0]
[@LEVEL] [@LEVEL] [0] [5]
Set to 55% [5] [5]
[@LEVEL] [@LEVEL] [5] [5]
Set to 100% [@LEVEL]
[@LEVEL] [@LEVEL] [@LEVEL]
Set to 70%* [@LEVEL] [@LEVEL] [7]
Set to 0% [@LEVEL]
[@LEVEL]
[@LEVEL] [@LEVEL] [@LEVEL]
[@LEVEL]
Set to 0% [C] & [-%] [C] & [-%]
Add 5% [+%] [+%]
Subtract 5% [-%] [-%]
Select ch # and add 5% [#] [+%] [#] [+%]
Select ch # and subtract
5% [#] [-%] [#] [-%]
Increase level by #% [#] [.] [+%]
Diminish level by #% [#] [.] [-%]
Revert to last used level
(Undo) [ON/FETCH] &
[@LEVEL] [ON/FETCH] & [@LEVEL]
*This is the Step Level value of the SETUP for the Level key. You can change it by holding
SETUP and pressing @LEVEL.
NOTE
There is a function for setting the last recorded level, and for fetching
levels from any recorded Preset.
See Presets - Fetch Intensities