ETC Congo Family v6.4.0 - Manual (Page 69)

67
Installation guidelines
Equipment required to run this system
• Congo, Congo Jr, Congo Lightserver, Net3 RVI, Client software
• Monitor(s) starting at 1024 x 768 resolution
• Power cables
• Monitor signal cable(s) - with Congo Jr you need a split from DVI to VGA
• DMX512 or Ethernet cable(s) to external equipment
Connect the monitor signal cable(s) from the back of the console to the monitor(s), and then
connect the power cables to a 230/110V outlet and start all units. After approximately 30
seconds Congo should be running.
If not then check:
• Is each monitor is set for VGA IBM compatible mode?
• Is each monitor cable is properly connected?
• Is each monitor power on?
NOTE
The Congo Jr ONLY supports monitors from the dual DVI connector.
You NEED the split DVI to VGA converter to connect a VGA monitor
to Congo Jr.
See Power-up Procedure .