ETC Congo Family v6.4.0 - Manual (Page 770)

768
If several masters have Fade type = Solo, the last Solo master that
leaves its 0% position will have priority over the other Solo masters.
To take control with another Solo master, move it down to 0% and up
again.
Flash settings (6.1)
The flash button is the lower key in all master modules. Some modules and the large Congo
only have flash keys for the lower row of faders. The different modes apply to specific
content types - which is described in greater detail in the tables below.
Flash Button
Mode Applies to Feedback
Off - Flash button is disabled
Momentary Ch, group, preset,
effect, chase,
Sequence Sets the fader to full or the
defined flash level when pressed
and returns the fader to zero
when the key is released.
Latching Ch, group, preset,
effect, chase,
Sequence Toggles the fader to full or the
defined flash level when
pressed, leaving the fader at that
level until the flash key is
pressed again
GoBack Chase, Sequence GoBack to previous step
Tap Chase Sets tap tempo
Flash type
Mode Applies to Feedback
Add Ch, group, preset,
effect Intensities are piled (HTP) on
top of the output. Attributes are
LTP.
Solo Ch, group, preset,
effect The content of this fader
replaces all other master faders
and returns other faders based
on the Momentary/Latching
mode setting.