ETC Congo Family v6.4.0 - Manual (Page 916)

914
Refresh functions
The Refresh Functions are used to reset any intensity or attribute that has been altered since
the last crossfade in the Main Playback - back to where it would have been if the sequence
had been run from the start.
DESCRIPTION SYNTAX
Refresh all channels [REFRESH]
Refresh the intensity of selected channel(s) [REFRESH] & [@LEVEL]
Refresh the attributes of all or selected
channel(s) [REFRESH] & [ATTRIB]
Refresh a parameter of all or selected
channel(s) [REFRESH] &
[Wheel_key]
Refresh Focus Parameters of selected
channel(s) [REFRESH] & [FOCUS]
Refresh Color Parameters of selected
channel(s) [REFRESH] & [COLOR]
Refresh Beam Parameters of selected
channel(s) [REFRESH] & [BEAM]
Shortcuts - Sequence Editor
These are shortcut in the Sequence List that will set times directly to the focused step
DESCRIPTION SYNTAX
Set an In/Out Time [#] [TIME]
Set an In Time [#] [IN]
Set an Out Time [#] [OUT]