ETC Congo Family v6.4.0 - Manual (Page 998)

996
RDM Device Parameter List (6.2)
The Device Parameter List provides access to the settings of each device that can be seen
and controlled over RDM. This list is only available when there are discovered RDM devices.
It is opened from the RDM Device List by pressing MODIFY in the Parameter cell of the
device you wish to adjust. Note that regardless of which device you use to open this tab, it
will show all devices of that model in the same table.
All data in this tab is generated by the RDM device and is then displayed by Congo.
Parameters you can edit are shown in white text. Changes you make in this tab are sent
directly to the device and are not stored in any way by Congo. The valid data for a parameter
is wholly dependent on the way the device manufacturer has developed their RDM
functionality. Valid input may be numerical (type the new value and press MODIFY) or may
be entered using a drop down menu (usually shown in text). Consult the user manual for the
device to understand the impact of changing parameters in this tab.
RDM Device Sensor List (6.2)
The Device Sensor List provides access to the sensor information an RDM Device transmits
(read-only). This list is only available when there are discovered RDM devices. It is opened
from the RDM Device List by pressing MODIFY in the Sensors cell of the device whose
sensor data you wish to view. Regardless of which device you use to open this tab, it will
show all devices of that model in the same table.