ETC Congo Family v6.4.0 - Manual (Page 614)

612
Device Times - Individual or FCB (6.0)
Device times can be set to individual parameter of selected devices, or to a parameter group
like Focus, Color or Beam for all devices in the preset.
FCB times are defaulted to run in 100% of the main In and Delay times for a step. You can
change this percentage or set an absolute time in seconds. An individual parameter time
always wins over a general FCB time.
Times are shown in the playback view. Individual parameter times are shown as a red dot at
the end of FCB timelines.
Setting times in the advanced recording popup
You can set these times directly in the Advanced tab of the
Recording Popup when you
record a new preset.
Setting times with key shortcuts
You can set times with a key shortcut by entering the time, holding TIME and pressing a
destination key (see table).
You will get a popup asking if you want to set the times on a general FCB -level for all
devices, or as individual Parameter Times for the selected devices.