ETC Congo Family v6.4.0 - Manual (Page 315)

313
Patch - Rename Channels
You can change the number used to access your instruments, without altering your Patch.
This is useful when you want to keep your addresses and dimmer assignments as they are,
but you want to change the numbering to fit the numbering of a Plot. Renaming is done in
the Name column of the Channel List (BROWSER >Patching >Channel List)
Change a channel name
Function Key Feedback
Change name [#] [MODIFY] Enter a new name and
press MODIFY. If the
name exists you will get a
warning message about
this.
Change names [#] [MODIFY] Select several cells, enter
a start name and press
MODIFY.
Remove selected channel(s)
from all channel views [0] [MODIFY] If a Name is set to zero,
the channel will disappear
from all channel views and
cannot be accessed until
given a name.*
Clear all channel names Patch Wizard All Channel Renames can
be cleared from the Patch
Wizard.
Set names 1:1 Patch Wizard The Rename function can
be reset from the Patch
Wizard.
*It will not disappear from Channel Layouts.