Rockwell Automation 1397 DC Drive Firmware 2.xx - Manual (Page 104)

4–32 Start–Up and Adjustment
Publication 1397-5.0 — June, 2001
Figure 4.14
Clockwise (CW) Rotation
Clockwise (CW) Rotation w/ Stab Shunt Motor
Bulletin 1397
F1 ( + )
Straight Shunt Machine,
CW Rotation, Facing Commutator End
F1 ( + )
A1
A1
A2
A2
F2 ( – )
( 2 )
Motor (1)
( – ) 45
F2 ( – )
( 2 )
Bulletin 1397
F1 ( + )
Basic Stabilized Shunt Machine,
CW Rotation, Facing Commutator End
F1 ( + )
A1
A1
A2
S1
S2
F2 ( – )
( 2 )
( 2 )
Motor (1)
( – ) 45
F2 ( – )
No Feedback Device Installed (Armature Voltage Control)
1. Verify that [Feedback Type] (P. 039) is set to Arm Volt for
armature voltage control.
2. Proceed to Verification of Drive Calibration sequence.