Ce conformity – Rockwell Automation 1397 DC Drive Firmware 2.xx User Manual
Page 233
Appendix
B
Publication 1397-5.0 — June, 2001
CE Conformity
This appendix provides information on installing 1397 Drives for
compliance with European Union Electromagnetic Compatibility
(EMC) Standards. It covers:
D Requirements for standards compliance
D Guidelines on installing the AC mains filter and inductor
D Instructions on how the Drive must be installed, wired, and
grounded for compliance. These instructions are in addition to the
normal installation instructions.
IMPORTANT: This appendix is not applicable to 1397 drives
rated above 300HP @460 VAC. These higher horsepower drives
are not designed to be CE-compliant.
For the 1397 Drive to conform to the standards listed on the
Declaration of Conformity (DOC) above, the Drive must:
D Be accompanied by the DOC for that Drive
D Be specified by model number on the DOC
D Have a CE mark, which is below the Drive nameplate
D Be mounted and wired on the conductive, non-coated back panel
of an electrical cabinet.
D Include an AC Line filter and inductor as specified in this
Appendix.
D Be installed according to the instructions in this Appendix
D Be operated with the electrical cabinet doors closed.
NOTE: Conformity of the 1397 Drive does not guarantee that the
entire installation will be in conformance.
In addition to the Drive, you will need the following to install the
1397 for CE compliance:
D Electrical cabinet with back mounting panel
D AC Line filter
D AC Line inductor
Mounting Panel and Electrical Cabinet Selection – The 1397
Drive, AC Line filter, AC Line inductor, and any other electronic or
electrical equipment must be mounted in an electrical cabinet. The
back mounting panel where this equipment is mounted must have a
good electrically conductive surface, such as aluminized cold-roll
steel, Galvalume, or galvanized steel. It must be free of any
insulating coatings, such as varnish or paint. This establishes a good
ground plane for the mounted equipment.
EMC Compliance
EMC Requirements
Equipment Requirements