Rockwell Automation 1397 DC Drive Firmware 2.xx User Manual
Page 167
5–57
Programming Parameters
Publication 1397-5.0 — June, 2001
OUTPUT CONFIG
[Anlg Out 3 Type] — P.152
Only used if the I/O Expansion kit is installed.
Selects the type of signal to be generated by
analog output 3 (terminals 54 and 55 on the
I/O Expansion board). This setting must
match the settings of jumpers J14 and J15 on
the I/O Expansion board.
Display/Drive Units:
Numeric/Text
Parameter Range:
0 = 0-10V
1 =
±10V
2 = 4 -20mA
3 = 10–50mA
Default Setting:
±10V
Parameter Type:
Configurable
Group:
Output Config
Factory Default:
1
Minimum Value:
0
Maximum Value:
3
[Anlg Out 4 Gain] — P.153
Adjusts analog output 4. Only used if I/O
Expansion kit is installed.
Display/Drive Units:
VDC
Parameter Type:
Tunable
Group:
Output Config
Factory Default:
1.000
Minimum Value:
0.500
Maximum Value:
1.300