Rockwell Automation 1397 DC Drive Firmware 2.xx - Manual (Page 66)

3–8 Programming Terminal
Publication 1397-5.0 — June, 2001
Process Mode
or
or
or
or
or
or
and
1. When selected, the Process mode will show
a custom display consisting of information
programmed with the Process Display group
of parameters.
A. Follow steps A-C on the preceding page
to access the Program mode.
B. Press the Increment/Decrement key until
“Process Display” is shown. Press Enter.
C. Using the Increment/Decrement keys,
select [Process 1 Par] and enter the
number of the parameter you wish to
monitor. Press Enter.
D. Select [Process 1 Scale] using the
Increment/Decrement keys. Enter the
desired scaling factor. Press Enter.
E. Select [Process 1 Txt 1] using the
Increment/Decrement keys. Enter the
desired text character. Press Enter and
repeat for the remaining characters.
F. If desired, a second display line can also
be programmed by repeating steps A-E
for [Process 2 xxx] parameters.
G. When process programming is com-
plete, press ESCape until “Choose
Mode” is displayed. Press Increment/
Decrement until “Process” is displayed.
H. Press Enter. This selects which custom
display will be on line 1 and line 2. Use
the Increment/Decrement keys to select
process 1 or 2 parameters for line 1.
I. Press SELect to move to line 2. Select
the desired process parameters. A zero
can be entered to disable line 2. In
addition, the Process Display can be set
to appear when Drive power is applied
by simultaneously pressing the Incre-
ment and Decrement keys while the
Process Display active.
Choose Mode
Program
Choose Mode
Process
Process Var 1=1
Process Var 2=2
Choose Group
Process Display
Process 1 Par
5
Process 1 Scale
1.00
Process 1 Txt 1
V
Sets Process Display
as Power-Up Display
+