Rockwell Automation 1397 DC Drive Firmware 2.xx - Manual (Page 9)

Chapter
1
Publication 1397-5.0 — June, 2001
Introduction
The purpose of this manual is to provide you with the necessary
information to install, program, start up and maintain the 1397 DC
Drive. This manual should be read in its entirety before operating,
servicing or initializing the 1397 Drive. This manual must be
consulted first, as it will reference other 1397 manuals for option
initialization.
This manual is intended for qualified service personnel responsible
for setting up and servicing the 1397 DC Drive. You must have
previous experience with and a basic understanding of electrical
terminology, programming procedures, required equipment and
safety precautions, as typical applications will consist of a properly
rated DC motor, with or without feedback based on performance
requirements, and the 1397.
!
ATTENTION: Only qualified electrical personnel
familiar with the construction and operation of this
equipment and the hazards involved should install,
adjust, operate and/or service this equipment. Read and
understand this section in its entirety before
proceeding. Failure to observe this precaution could
result in bodily injury or loss of life.
ATTENTION: An incorrectly installed or applied
drive can result in component damage or a reduction in
product life. Wiring or application errors such as
undersizing the motor, incorrect or inadequate AC
supply or excessive ambient temperatures may result in
damage to the Drive or motor.
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static
control precautions are required when installing,
testing, servicing or repairing this assembly.
Component damage may result if ESD control
procedures are not followed. If you are not familiar
with static control procedures, reference Allen–Bradley
Publication 8000 – 4.5.2, Guarding against
Electrostatic Damage or any other applicable ESD
protection handbook.
Manual Objectives