Metrohm 751 GPD Titrino - Manual (Page 112)

3.1 General rules
751 GPD Titrino
109
$G .Mode.DOC...
As STAT.
$G .Mode.MEAS .Inac :
Instrument at the beginning or at the end of a titration.
.Req .Id1 :
Instrument in the MEAS mode, requesting Id1 after start.
.Id2 :
Instrument in the MEAS mode, requesting Id2 after start.
.Id3 :
Instrument in the MEAS mode, requesting Id3 after start.
.Smpl :
Instrument in the MEAS mode, requesting sample size after start.
.Unit :
Instrument in the MEAS mode, requesting unit of sample size after start.
.Meas :
Instrument in the MEAS mode, measuring.
$G .Mode.CAL .Inac :
Instrument at the beginning or at the end of a calibration
.Req.Temp :
Instrument in the CAL mode, requesting calibration temperature.
.Meas.Temp :
Instrument in the CAL mode, measuring calibration temperature.
.Req.Buf1 :
Instrument in the CAL mode, requesting pH of buffer 1.
.Meas.Buf1 :
Instrument in the CAL mode, measures buffer 1.
.Req.Buf2 :
Instrument in the CAL mode, requesting pH of buffer 2.
.Meas.Buf2 :
Instrument in the CAL mode, measures buffer 2.
etc.
$G .Assembly.Bur .Fill :
Buret in filling process
.ModeDis :
Buret in DIS mode
$G .Prep.X.Active :
Preparing buret X, X=0, 1, 2.
.Empty.X.Active :
Emptying buret X, X=1, 2.
In TIP, its global status as well as the step number (X) is available.
$G .TIP.X .Inac :
Instrument at the beginning or at the end of a TIP.
.Req .Id1 :
Instrument in the TIP mode, requesting Id1 after start.
.Id2 :
Instrument in the TIP mode, requesting Id2 after start.
.Id3 :
Instrument in the TIP mode, requesting Id3 after start.
.Smpl :
Instrument in the TIP mode, requesting sample size after start.
.Unit :
Instrument in the TIP mode, requesting unit of sample size after start.
.Pause :
Instrument in the TIP mode, in pause.
.Info :
Instrument in the TIP mode, in info.
.Mode... :
Instrument in the TIP mode, working off a submethod. The detailed status
messages of the submethod appear, see above.
Status conditions of the global $H:
The status message of the action which has been held appears.
If the process is held because a monitored limit has been violated, its status
message is $H.Mode.XXX.Titr.
Status conditions of the global $C:
The status conditions of the global $C are identical with the ones of the global
status $G. They appear when the process has been restarted actively from the
status "Hold" ($C, key <meas/hold> or automatically after elimination of an
error).