Metrohm 751 GPD Titrino - Manual (Page 13)

2.4. Configuration, key <CONFIG>
751 GPD Titrino
10
start delay 0 s
result display: bold
dev.label.
program 751.0020
Start delay (0...999 999 s)
Delay time after start of methods. Abort start delay time
with <QUIT>.
Type of result display at the end of the determination
(bold, standard)
bold: The calculated results are displayed in bold
characters.
standard: Displays the whole information, e.g. results,
endpoints, messages etc.
Individual identification of devices (up to 8 ASCII
characters)
Will be printed in the result report, see page 81.
Display of program version
>RS232 settings COM1
baud rate: 9600
data bit: 8
stop bit: 1
parity: none
handshake: HWs
Settings of RS232 interface
see also page 180. Identical for COM2.
Baud rate (300, 600, 1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200)
Data bit (7, 8)
Stop bit (1, 2)
Parity (even, odd, none)
Handshake (HWs, SWline, SWchar, none)
see page 180.
>common variables
C30 0.0
etc.
Values of the common variables
Common variables C30...C39 (0.. ± 999 999)
The values of all common variables are displayed. For
creating of common variables see page 79.
>prep.dosing elements
power ON prep: OFF
report: OFF
Preparation of titration burets, "prep" and
"empty"
see also page 103
Warning after power ON (ON, OFF)
If this function is on, a warning appears after switching
on the Titrino, that a preparation should be executed.
Report of prep (ON, OFF)
With ON, a report will be printed automatically after
prep. The report is outputted on the COM which is
given for manual reports.