Metrohm 751 GPD Titrino - Manual (Page 141)

3.2. Remote control commands
751 GPD Titrino
138
³ "Info", continuation
à .ActualInfo Current data
³ Ã .Inputs I/O Inputs
³ ³ Ã .Status Line status read only 3.2.2.140.
³ ³ Ã .Change Change of line status read only ditto
³ ³ Ã .Clear Clear change $G ditto
³ Ã .Outputs as for I/O Inputs
³ Ã .Assembly From Assembly
³ ³ Ã .CyclNo Cycle number read only 3.2.2.141.
³ ³ Ã .Counter Assembly counter read only 3.2.2.142.
³ ³ ³ Ã .V Volume counter read only ditto
³ ³ ³ Ã .Clear Clears counter $G ditto
³ ³ Ã .Meas Measured value read only 3.2.2.143.
³ Ã .Titrator From Titrator
³ ³ Ã .CyclNo Cycle number read only 3.2.2.144.
³ ³ Ã .V Volume read only ditto
³ ³ Ã .Meas Measured indicator voltage read only ditto
³ ³ Ã .dVdt Volume drift dV/dt read only ditto
³ ³ Ã .dMeasdt Measured value drift read only ditto
³ ³ Ã .dMeasdV 1st deviation of titration curve read only ditto
³ ³ Ã .ERC ERC from DET read only ditto
³ ³ Ã .T Temp.as secondary meas. read only ditto
³ Ã .MeasPt Entry in measuring point list
³ ³ Ã .Index Index of entry read only 3.2.2.145.
³ ³ Ã .X X coordinate read only ditto
³ ³ Ã .Y Y coordinate read only ditto
³ ³ Ã .Z1 Z1 coordinate read only ditto
³ ³ Ã .Z2 Z2 coordinate read only ditto
³ Ã .EP EP entry
³ ³ Ã .Index Index of entry read only ditto
³ ³ Ã .X X coordinate read only ditto
³ ³ Ã .Y Y coordinate read only ditto
³ Ã .Oven Oven data
³ ³ Ã .HeatTime Heating time read only 3.2.2.146.
³ ³ Ã .SampleTemp Sample temperature read only ditto
³ ³ Ã .LowTemp Lowest temperature read only ditto
³ ³ Ã .HighTemp Highest temperature read only ditto
³ ³ Ã .GasFlow Gas flow read only ditto
³ ³ Ã .UnitFlow Unit of gas flow read only ditto
³ Ã .Display Display
³ ³ Ã .L1 Text line 1 up to 32 ASCII char 3.2.2.147.
³ ³ Ã up to line 8
³ ³ Ã .DelAll Delete display $G ditto
³ Ã .Comport Comport
³ ³ Ã .Number COM where PC is connected read only 3.2.2.148.
³
à .Assembly Assembly
³ Ã CycleTime Cycle time read only 3.2.2.149.
³ Ã ExV Volume of Exchange/Dosing unit read only ditto