Metrohm 751 GPD Titrino - Manual (Page 150)

3.2 Remote control commands
751 GPD Titrino
147
Parameters for DET, MET, SET, KFT, STAT, DOS, DOC: Stop volume. (With
DOS the default value for .Type is "OFF" and the input range for V is
0...99999.99.)
If an absolute stop volume (abs.) has been selected, the volume in mL is valid.
A relative stop volume (rel.) is dispensed as a function of the sample size:
Stop volume in mL = smpl size
*
factor
The factor is valid.
OFF means that the criterion is not monitored.
3.2.2. 3.2.2.21. 21. M Mode.P .Parameter.S .StopCond.M .MeasStop pH: 0... ± 20.00, OFF OFF
U: 0... ± 2000, OFF OFF
I: 0...200.0, OFF OFF
M Mode.P .Parameter.S .StopCond.U .UnitMStop read only
Parameters for DET and MET: Stop when a measured value is reached. Entry
as pH value, in mV (with U and Ipol) and in uA (with Upol). The appropriate unit
can be viewed with .UnitMStop.
OFF means that the criterion is not monitored.
3.2.2. 3.2.2.22. 22. M Mode.P .Parameter.S .StopCond.E .EPStop 1...99, OFF
Parameters for DET and MET: Stop when a certain number of EP's has been
found.
OFF means that the criterion is not monitored.
3.2.2. 3.2.2.23. 23. M Mode.P .Parameter.S .StopCond.F .FillRate 0.01...150, max. max.
Parameters for DET, MET, SET, KFT, STAT, DOS, DOC: Filling rate in the titra-
tion in mL/min. Max. means maximum possible filling rate with the Exchange
Unit in current use.
3.2.2. 3.2.2.24. 24. M Mode.P .Parameter.Sta .Statistics.S .Status ON, OFF OFF
M Mode.P .Parameter.Sta .Statistics.M .MeanN 22...20
M Mode.P .Parameter.Sta .Statistics.R .ResTab.S .Selected original original, delete n,
delete all
M Mode.P .Parameter.Sta .Statistics.R .ResTab.D .DelN 11...20
Entries for the statistics calculations.
.Status:
On/off switching. Requirement for statistics calculations is a valid
assignment, see 3.2.2.9.
.MeanN: Number of individual results for statistics calculations.
.ResTab.Select: Selection of the table for the statistics calculations.
original: Original table. The original table is (again) set up, i.e. any
individual results which have been deleted are reincorporated
in the statistics calculations.
delete n: Single result lines are removed from the statistics calcula-
tion. All results of the corresponding line in the statistics table
are deleted. Specification of the line number in .ResTab.DelN.
delete all: Clear entire statistics table. The results can not be reacti-
vated.