Metrohm 751 GPD Titrino - Manual (Page 170)

3.2 Remote control commands
751 GPD Titrino
167
scalc srt: Short report of the silo calculations.
prep:
Preparation report.
calc: Calculation report of the current method.
act dir: Methods of the current directory of the memory card.
mem card: All methods of the memory card.
all:
All reports.
ff: Form feed on printer.
Reports which are sent from the Titrino are marked with space (ASCII 32) and '
at the beginning. Then an individual identifier for each report follows. Reports
which are triggered by RS232 ($G) have the same introducer but without pre-
ceding space, i.e. they start with '.
3.2.2. 3.2.2.131. 131. IInfo.C .CalibrationData $G
IInfo.C .CalibrationData.I.Inp1.p .pHas -20.00...7.00 7.00...+20.00
IInfo.C .CalibrationData.I.Inp1.S .Slope -9.999...1.000 1.000...+9.999
IInfo.C .CalibrationData.I.Inp1.T .Temp -170.0...25.0 25.0...+500.0
IInfo.C .CalibrationData.I.Inp1.D .Date read only
IInfo.C .CalibrationData.I.Inp1.E .ElectrodeId read only
identical for .Inp2 and .Diff
pH calibration data for measuring input 1. After the calibration, the data are en-
tered automatically together with the date of the calibration and the electrode
identification, see 3.2.2.71.
Calibration data can be entered. They are accepted with &Info.CalibrationData
$G. If calibration data are entered, the calibration date is deleted.
3.2.2. 3.2.2.132. 132. IInfo.P .PrepData.DD0.DDate read only
IInfo.P .PrepData.DD0.TTime read only
IInfo.P .PrepData.D1 D1.TType read only
IInfo.P .PrepData.D1 D1.DDate read only
IInfo.P .PrepData.D1 D1.TTime read only
identical to .D2
Data from the last correctly executed preparation.
3.2.2. 3.2.2.133. 133. IInfo.Ch .Checksums $G
IInfo.Ch .Checksums.M .MPList read only
IInfo.Ch .Checksums.A .ActualMethod read only
The checksums can be used to identify the content of a file unequivocally, e.g.
files with identical content
have identical results of the checksums. An empty file has checksum "0". The
calculation of the checksums is triggered with $G.
.MPList:
Result of the checksum of the current measuring point list.
.ActualMethod: Result of the checksum of the current method in the working
memory. Identical methods with different method names have the
same results of the checksum.
3.2.2. 3.2.2.134. 134. IInfo.D .DetermData $G
IInfo.D .DetermData.W .Write ON, OFF OFF
IInfo.D .DetermData.M .MPList.1.A .1.Attribute read only/read+write