Deleting the next-startup configuration file, Displaying and maintaining configuration files – H3C Technologies H3C S12500 Series Switches User Manual
Page 117
105
Deleting the next-startup configuration file
CAUTION:
This task permanently deletes the next-startup configuration file from each MPU. Before performing this
task, back up the file as needed.
Delete the next-startup configuration file if one of the following occurs:
•
After you upgrade system software, the file does not match the new system software.
•
The file is corrupted or not fully compatible with the device.
After the file is deleted, the switch uses factory defaults at next startup.
Perform the following task in user view:
Task Command
Delete the next-startup configuration file.
reset saved-configuration
Displaying and maintaining configuration files
Task Command
Remarks
Display information about
configuration rollback.
display archive configuration [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display the running configuration.
display current-configuration [ configuration
[ configuration ] | interface [ interface-type
[ interface-number ] ] | exclude modules ]
[ by-linenum ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display the next-startup
configuration file.
display saved-configuration [ by-linenum ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display the factory defaults of the
switch.
display default-configuration [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display names of the configuration
files used at this startup and next
startup.
display startup [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display the valid configuration in
the current view.
display this [ by-linenum ] [ | { begin |
exclude | include } regular-expression ]
Available in any view.