Using the extend-bootware menu, Using the extend-bootware, Menu – H3C Technologies H3C S12500 Series Switches User Manual
Page 207
195
Using the EXTEND-BOOTWARE menu
To access the EXTEND-BOOTWARE menu, press Ctrl + B within 3 seconds after the " Press Ctrl+B to enter
extended boot menu..." prompt message appears. If you fail to do this, the system starts decompressing
the system software.
DDR2 SDRAM test successful.
Press Ctrl+T to start five-step full RAM test...
Press Ctrl+Y to start nine-step full RAM test...
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Booting Normal Extend BootWare
The Extend BootWare is self-decompressing................
Done!
****************************************************************************
* *
* H3C S12500 BootWare, Version 1.22 *
* *
****************************************************************************
Copyright (c) 2004-2012 Hangzhou H3C Technologies Co., Ltd.
Compiled Date : Dec 3 2012
CPU Type : MPC8548E
CPU L1 Cache : 32KB
CPU L2 Cache : 512KB
CPU Clock Speed : 1000MHz
Memory Type : DDR2 SDRAM
Memory Size : 1024MB
Memory Speed : 400MHz
BootWare Size : 4MB
Flash Size : 128MB
cfa0 Size : 247MB
NVRAM Size : 1024KB
BASIC CPLD Version : 003
EXTEND CPLD Version : 003
PCB Version : Ver.B
Board self testing...........................
Board steady testing... [ PASS ]
Board SlotNo... [ 1 ]
Subcard exist testing... [ PASS ]
DX246 testing... [ PASS ]
PHY88E1111 testing... [ PASS ]
CPLD1 testing... [ PASS ]
CPLD2 testing... [ PASS ]
NS16550 register testing... [ PASS ]
The default switch's Mac address... [00:e0:fc:00:95:12]