Upgrading cplds – H3C Technologies H3C S12500 Series Switches User Manual
Page 129
117
To upgrade MBUS daughter card software, perform one of the following tasks in user view:
Task Command
Upgrade the MBUS daughter card software on a card
(in standalone mode).
mbus update [ file file-url ] slot slot-number
Upgrade the MBUS daughter card software on a card
(in IRF mode).
mbus update [ file file-url ] chassis chassis-number slot
slot-number
Upgrading CPLDs
To ensure a successful CPLD upgrade, follow these guidelines:
•
In IRF mode, the CPLD upgrade file for a subordinate switch must be saved on its active MPU, and
the CPLD upgrade file for the master switch can be saved on its active or standby MPU.
•
Make sure no one performs any of the following operations during the upgrade:
{
Perform an active/standby switchover.
{
Power off or reboot the switch.
{
Reboot or swap the active MPU.
When the upgrade is complete, the card automatically reboots to validate the upgraded CPLD.
If you install an interface card during a CPLD upgrade, the system can supply power to the card only after
the upgrade is complete.
To upgrade a CPLD on an interface card or MPU:
Step Command
Remarks
1.
Set the interface card in
offline state.
a.
Enter system view.
system-view
b.
Isolate the interface card.
In standalone mode:
board-offline slot
slot-number
In IRF mode:
board-offline chassis
chassis-number slot
slot-number
c.
Return to user view.
quit
Skip this step if you are upgrading
CPLDs for an MPU.
In offline state, an interface card
cannot forward traffic.
2.
Upgrade a CPLD on the
interface card or MPU in user
view.
•
In standalone mode:
logic update bymbus [ file
filename ] slot slot-number
logicid logicid
•
In IRF mode:
logic update bymbus [ file
filename ] chassis
chassis-number slot slot-number
logicid logicid
The logicid argument specifies the
CPLD type:
•
0—Card (interface card or
MPU) CPLD.
•
1—OAM module CPLD on an
MPU, or CPU CPLD on an
interface card.