H3C Technologies H3C S12500 Series Switches - Manual (Page 177)

165
Support for the system operating modes depends on the card type. The following table illustrates the
correspondence.
System operating mode EB card EC card EF card OAA card
standard Supported Supported Supported Supported
bridgee Not supported Supported Supported Supported
routee Not supported Supported Supported Supported
advance Not supported Not supported Supported Not supported
An EB card has a silkscreen ended with EB, for example, LST1GT48LEB1. An EC or EF card has a
silkscreen ended with EC or EF.
The default parameters of some commands vary with system operating modes. Those parameters that do
not vary with different system operating modes are not listed in the table. The following table illustrates
the details.
Command Argument
Operating mode and default value
Standard Bridgee Routee Advance
multicast-vlan ipv6
entry-limit limit
limit 511 4095 4095 4095
multicast-vlan
entry-limit limit
limit 2047 4096 16384 30720
mac-table limit
mac-limit-num
mac-limit-num
Not
supported
131072 65536 131072
multicast
forwarding-table
route-limit limit
limit 2047 4096 16384 30720
mld group-limit limit limit 2048 8192 8192 8192
ip verify source
max-entries number
number 1536
7680 (without
the acl ipv6
enable
command
configured)
3584 (with the
acl ipv6 enable
command
configured)
7680 (without
the acl ipv6
enable
command
configured)
3584 (with the
acl ipv6 enable
command
configured)
32256
(without the acl
ipv6 enable
command
configured)
15872 (with
the acl ipv6
enable
command
configured)
ipv6 verify source
max-entries number
number 1536 3584 3584 15872
Scheduling jobs
You can schedule a job to automatically run a command or a set of commands without administrative
interference. The commands in a job are polled every minute. When the scheduled time for a command
is reached, the job automatically executes the command. If a confirmation is required while the