Recovering the bootware image, Upgrading the bootware image – H3C Technologies H3C S12500 Series Switches User Manual
Page 219
207
Begin to backup the Basic BootWare..Done!
Will you backup the Extend BootWare? [Y/N]Y
Begin to backup the Extend BootWare.Done!
Recovering the BootWare image
If the BootWare image has been corrupted, you can use a backup BootWare image to recover it.
Enter 2 in the BootWare Operation menu to recover the BootWare image. You may choose to recovery
the entire image, its basic segment, or extended segment.
Enter your choice(0-4): 2
Will you restore the Basic BootWare? [Y/N]Y
Begin to restore Normal Basic BootWare..Done!
Will you restore the Extend BootWare? [Y/N]Y
Begin to restore Normal Extend BootWare.Done!
Upgrading the BootWare image
You can upgrade the BootWare image through the console port or an Ethernet port.
To upgrade the BootWare image through the console port, entre 3 in the BootWare Operation menu.
Enter your choice(0-4): 3
====================<BOOTWARE OPERATION SERIAL SUB-MENU>====================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):4
Table 28 BOOTWARE OPERATION SERIAL submenu options
Option Task
<1> Update Full BootWare
Upgrade the entire BootWare image.
<2> Update Extend BootWare
Upgrade the extended segment.
<3> Update Basic BootWare
Upgrade the basic segment.
<4> Modify Serial Interface Parameter
Modify the baud rate of the console port.
Perform this task before you perform any upgrade task.
<0> Exit To Main Menu
Return to the BootWare Operation menu.
To upgrade the BootWare image through the management Ethernet port, enter 4 in the BootWare
Operation menu.
Enter your choice(0-4):4
===================<BOOTWARE OPERATION ETHERNET SUB-MENU>===================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
============================================================================