Own in, Figure 4 – H3C Technologies H3C S12500 Series Switches User Manual
Page 35
23
Figure 4 Connecting a terminal to the console port
2.
Connect the RJ-45 connector of the console cable to the console port of the MPU of the switch. If
two MPUs are installed on the switch, log in through the console port on the active MPU (typically
with a smaller slot number) for the first login.
NOTE:
•
Identify the mark on the console port and make sure you are connecting to the correct port.
•
The serial ports on PCs do not support hot swapping. If the switch has been powered on, always
connect the console cable to the PC before connecting to the switch, and when you disconnect the
cable, first disconnect from the switch.
3.
If the PC is off, turn on the PC.
4.
Launch the terminal emulation program and configure the communication properties on the
terminal.
through
shows the configuration procedure on Windows XP HyperTerminal.
Make sure the port settings are the same as listed in
.