H3C Technologies H3C S12500 Series Switches - Manual (Page 34)

22
Logging in through the console or AUX port
The AUX port can be used as the backup of the console port. Using the AUX port for local login is the
same as using the console port. This example describes the console port configuration and login
procedure.
By default, the first time you access the CLI you must log in through the console port.
To log in through the console port, make sure the console terminal has a terminal emulation program (for
example, HyperTerminal in Windows XP) and the port settings of the terminal emulation program are the
same as the default settings of the console port shown in Table 10 .
Table 10 Default console port settings
Setting Default
Baud rate 9600 bps
Flow control Off
Check mode No check bit
Stop bits 1
Data bits 8
To log in through the console port:
1. As shown in Figure 4 , connect the DB-9 connector of the console cable to the serial port of your
console terminal.