Scheduling a job by using the non-modular method, Scheduling a job by using the modular method, Scheduling a job by using the – H3C Technologies H3C S12500 Series Switches User Manual
Page 179: Non-modular method, Modular method
167
{
Input a view name in its complete form. Most commonly used view names include monitor for
user view, system for system view, GigabitEthernet x/x/x for Ethernet interface view, and
Vlan-interfacex for VLAN interface view.
{
The time ID (time-id) must be unique in a job. If two time and command bindings have the same
time ID, the binding configured most recently takes effect.
Scheduling a job by using the non-modular method
To schedule a job, perform one of the following commands in user view:
Task Command
Remarks
Schedule a job.
•
Schedule a job to run a command at a
specific time:
schedule job at time [ date ] view view
command
•
Schedule a job to run a command after
a delay:
schedule job delay time view view
command
Use either command.
NOTE:
•
If you execute the schedule job command
multiple times, the most recent
configuration takes effect.
•
Changing any clock setting can cancel
the job set by using the schedule job
command.
Scheduling a job by using the modular method
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a job and
enter job view.
job job-name N/A
3.
Specify the view in
which the
commands in the
job run.
view view-name
You can specify only one view for a
job. The job executes all commands
in the specified view.
4.
Add commands to
the job.
•
Configure a command to run at a
specific time and date:
time time-id at time date command
command
•
Configure a command to run at a
specific time:
time time-id { one-off | repeating } at
time [ month-date month-day |
week-day week-daylist ] command
command
•
Configure a command to run after a
delay:
time time-id { one-off | repeating } delay
time command command
Use any of the commands.
NOTE:
Changing a clock setting does not
affect the schedule set by using the
time at or time delay command.