Honeywell PRESTIGE THX9321 - Manual (Page 36)

THX9321 PRESTIGE ® 2.0 AND THX9421 PRESTIGE ® IAQ WITH EIM
68-0311—02 36
3130 Radiant Heat
Cycles Per Hour -
Stage 2
1 to 12 CPH 3 Both No ISU 3010 Temperature Control Options
must be set to Advanced to view or adjust
cycle rate.
This ISU is only displayed when ISU 2010
Heating Equipment Type is Geothermal
Radiant Heat.
The thermostat automatically defaults to
the recommended setting for Geothermal
Radiant Heat (3 CPH).
Cycle rate limits the maximum number of
times the system can cycle in a 1 hour
period measured at a 50% load. For
example, when set to 3 CPH, at a 50% load,
the most the system will cycle is 3 times
per hour (10 minutes on, 10 minutes off).
The system cycles less often when load
conditions are less than or greater than a
50% load.
3140 Cool / Compressor
Cycles Per Hour -
Stage 1
Note: “Stage 1" is
not displayed if
there is only 1
stage.
1 to 6 CPH 3 Both No ISU 3010 Temperature Control Options
must be set to Advanced to view or adjust
cycle rate.
This ISU is only displayed when ISU 2070
Cool / Compressor Stages is set to 1 stage.
Cycle rate limits the maximum number of
times the system can cycle in a 1 hour
period measured at a 50% load. For
example, when set to 3 CPH, at a 50% load,
the most the system will cycle is 3 times
per hour (10 minutes on, 10 minutes off).
The system cycles less often when load
conditions are less than or greater than a
50% load.
3140 Cool / Compressor
Cycles Per Hour -
Stage 2
1 to 6 CPH 3 Both No ISU 3010 Temperature Control Options
must be set to Advanced to view or adjust
cycle rate.
This ISU is only displayed when ISU 2070
Cool / Compressor Stages is set to 2
stages.
Cycle rate limits the maximum number of
times the system can cycle in a 1 hour
period measured at a 50% load. For
example, when set to 3 CPH, at a 50% load,
the most the system will cycle is 3 times
per hour (10 minutes on, 10 minutes off).
The system cycles less often when load
conditions are less than or greater than a
50% load.
Table 4. Installer Setup (ISU) Table. (Continued)
ISU
Number
Installer Setup
Name Settings Default
Residential,
Commercial
or Both
Requires
EIM Notes