Rockwell Automation 865 Differential Protection Relay - Manual (Page 42)

2-30
Local Panel User Interface
865-UM001A-EN-P – July 2009
DEVICENET
The optional plug on DeviceNet Communication Module provides
the following features:
Node address and network data rate is programmable through the
front panel of the 865 relay.
Alternatively, the configuration settings can be accomplished
over the DeviceNet network, utilizing a network configuration
tool such as RSNetWorx for DeviceNet.
The status of the module is reported the status of the device bus
and network communications.
UCMM (Unconnected Message Manager) messages are
supported with the ability to allocate up to 3 explicit message
connections concurrently.
DeviceNet Group 2 slave functionality including:
– Explicit connection
– Polled connection
– 1 COS (Change of State)/Cyclic connection
Full DeviceNet Parameter Object support allows EDS files to be
extracted from all units.
TCP/IP [Ethernet]
These TCP/IP parameters are used by the ethernet interface module.
For changing the nnn.nnn.nnn.nnn style parameter values,
SetPointPS is recommended.
IP address [IpAddr].
Net mask [NetMsk].
Gateway [Gatew].
Name server [NameSw].
Network time protocol (NTP) server [NTPSvr].
Protocol port for IP [Port]. Default is 502.
Single Line Diagram Editing
The single-line diagram is drawn with the SetPointPS software. For
more information, please refer to the SetPointPS manual.
Configuration and
Parameter Setting
(cont.)