Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 101)

101
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Sets of Angles
∆ ∆ ∆ ∆ ∆
V
Displays the difference between the
current value of the Vertical Circle
and the first direction to the target
point. Displays as dashes during the
learning phase.
Slope Dist
Displays the distance to the target
point. Displays as dashes until a
distance is measured manually.
∆ ∆ ∆ ∆ ∆
SlopeDist
Displays the difference between the
current distance to the target point
and the first distance to the target
point. Displays as dashes during the
learning phase.
Point Id
Displays the Point Id of the point
currently being measured, as input
on the previous dialog.
Refl. Ht.
Displays the Reflector Height of the
point currently being measured, as
input on the previous dialog.
Hz
Displays the current value of the
Horizontal Circle.
V
Displays the current value of the
Vertical Circle.
∆ ∆ ∆ ∆ ∆
Hz
Displays the difference between the
current value of the Horizontal Circle
and the first direction to the target
point. Displays as dashes during the
learning phase.
Measure Mode, continued
Measure the distance to the
target point, record the
measurement results in the Meas
Job and return to the previous dialog.
Data will also be stored internally by
Sets of Angles.
Measure the distance to the
target point and remain at this
dialog.
Record the measurement
results in the Meas Job and
return to the previous dialog. Data
will also be stored internally by Sets
of Angles.
Store the measurement
results internally and return to
the previous dialog. Data will not be
stored in the Meas Job.
(May not be available) Check
and/or set the reflector type,
reflector height, ppms.