Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 23)

23
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Resection
Target Point
Enter the target point number and
height of the reflector.
Search the coordinates of the
point entered from the active
data job and go to the measure
mode.
Search and display the
coordinates of the point found
in the active data job.
Measure Mode
This dialog is similar to the
TPS1100’s basic "Measure Mode"
dialog. Once a measurement is
taken, the program will return to the
dialog "Target Point" to acquire the
next point for measuring. Record the measurement in
the active measurement job.
Return to the dialog "TARGET
POINT".
Accept the measurement and
return to the dialog "Target
Point".
Enter target data.
(See User Manual)
Change the theodolite
face.
Exit the program.
Simultaneously measure and
record data in the active
measurement job. Return to the
dialog "TARGET POINT".
Measure a distance.
Resec\ Target Point
Point Id : 30
Refl. Ht. : 1.300 m
SEARC VIEW
MC
Resec\ Measure
Point Id : 1
Hz : 286°55’50’’
V : 91°16’20’’
Refl. Ht. : 0.000 m
Slope Dist: -----
ALL DIST REC CONT TARGT
MC
I<>II QUIT