Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 118)

118
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Sets of Angles
Log File
If "LOG FILE" is set to ON the
measurements and the results are
stored in the ASCII-file specified
within the "Configuration Editor". This
file is created in the directory LOG on
the memory card. Subsequently, you
can read the memory card on your
PC and obtain a hard copy of the
Log-file.
Data will always be
appended to the specified
Log-file.
The Log-file contains the following
information:
Header
The header line will contain the
program used, information about the
instrument, the name of the data file
as well as date and time the program
was started.
Data
The average horizontal and vertical
angles of all sets, the standard
deviation for one measurement and
the standard deviation of an angle
averaged from all sets, are stored in
the Log-File. The following data are the result of
running Sets of Angles to measure
three sets to three target points and
computing the horizontal, vertical and
distance results (the same data as in
the Meas Job shown previously.)
Example of Logfile Data