Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 34)

34
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Tie Distance
User Disp
YES The same display mask as the
one used in the system
measurement dialog (MEAS)
is used for measurements with
"Tie Distance".
NO The "Tie Distance" default
display applies.
Log File
Set to ON, the program will record
measurement data in the Log File
according to the format described on
chapter "Log File".
Log FlName
Enter the Log File Name.
Meas. Job
Selection of the measurement job for
recording measurements.
Data Job
Selection of the data job containing
the fix point coordinates (control
data).
Store the current
configuration and proceed to
the dialog "MEASURE MODE".
Set the values to default.
Displays date and version of
the running application.
Exit the program.
Dual-face Measurement
In the dual-face mode, the program
will prompt for measurements in both
faces. When both measurements are
taken, the program will check the
difference between the two. If the
difference in angle is within 27'
(0.5 gon) and the difference of two
measured distances is within 0.5 m
(1.64 ft), the observations will be
averaged. These tolerances are used
to avoid errors in target identification.
If exceeded an error message will be
displayed.
Configuration Editor, continued