Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 16)

16
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Orientation and Height Transfer
More Information
Display the residuals of individual
measurements. You can also disable
points from the calculation of
orientation or height as well as delete
erroneous measured points. 2/10
Sequence number of the current
point and total number of points in
the measurement set. The scroll bar
shows the sequential position of the
measurements, graphically.
Status
Use this measurement for calculation
(ON/OFF).
Pt. Status
ON
Measurements to target point
used for calculation.
Ignore Elev.
Target point elevation disabled:
measurements for elevation
determination not used in
calculation.
OFF Target point disabled:
measurements to point NOT
used for calculation.
Error Flag
Identified erroneous measurements.
Possible values are:
NONE
measurement is OK
HZ horizontal angle error
DIST distance error
HT height difference error
The flags may also be combined, i.e.
DIST + HZ
Ori\ More Info
2/10
Point Id : 10
Pt. Status : Point01
Error flag : NONE
∆∆∆∆∆ Hz : 0°00'03"
∆∆∆∆∆ Dist. : 0.050 m
RECLC <-- --> MEAS DEL BACK
MC
∆∆∆∆∆ Ht : 0.020 m
Refl. Ht. : 1.555 m
East : 991.427 m
North : 1995.162 m
Elevation : 402.466 m