Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 155)

155
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en COGO
Search and display the
coordinates of the point found
in the active data job.
Exit the program.
If "Bearing" is selected in the
configuration for "Direc. Type:", then
the following dialog box appears: NorthEast
Enter magnetic bearing
If "Azimuth" is selected in the
configuration during "Direc. Type:",
then the azimuth of the straight line
can be entered.
Offset
Entering parallel displacement.
Only active if "YES" is entered in the
configuration during "Offset:"
Left = negative parallel offset
Right = positive parallel offset
Accept displayed values.
Determining the direction by
means of the function "Polar
calculation" (refer to chapter
"Inverse").
Quadrant
Enter quadrant:
1 = Northeast
2 = Southeast
3 = Southwest
4 = Northwest
Bearing-Distance Intersection, continued
COGO\ Bearing-Distance
Direction from 1st point
Quadrant : 1
NorthEast : 0°00’00’’
Offset : 0.000 m
CONT INV RCALL
MC
MODIF QUIT