Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 73)

73
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Reference Line
L&O Results dialog
The results dialog displays the
differences between entered and
measured data. There are two
methods to choose from: Orthogonal
and Polar.
For more information refer
to chapter "Method Dialog".
REFL\ L&O Results
Point Id : 14
Refl. Ht. : 1.300 m
∆∆∆∆∆ Offset : 0.332 m
∆ ∆ ∆ ∆ ∆ Line : 1.002 m
∆ ∆ ∆ ∆ ∆ Ht :CUT -1.011 m
Sollhöhe : 100.001 m
ALL DIST REC CONT POSIT
MC
METHD I<>II QUIT
Point Id
Point number of the point to be
staked.
Refl. Ht.
Reflector height used at target.
∆∆∆∆∆
Offset
(orthogonal stakeout)
Difference in transversal
displacement between actual and
calculated point.
+ : point is further to the right
- : point is further to the left
∆∆∆∆∆
Line
(orthogonal stakeout)
Difference in longitudinal
displacement between actual and
calculated point along reference.
+ : point is further along the reference
- : point is closer to beginning of ref.
∆∆∆∆∆
Hz
(polar stakeout)
Difference in Hz between actual and
calculated direction.
∆∆∆∆∆
Dist
(polar stakeout)
Difference in horizontal distance
between actual and calculated
values.
∆∆∆∆∆
Ht
Difference between design and
measured elevation. Expressed both
numerically and as CUT/FILL.
Elev.
Edit Elev. = OFF
Elevation of the measured point.
DesignElev.
Edit Elev. = ON
Elevation entered by user.
Simultaneously execute
distance measurement and
record the measurement.
Measure a distance.
Record the measurement in
the measurement job.
Return to previous L&O
dialog without recording data.
(Re-)position the telescope
on the target point. Note: this
function is only available for
motorized instruments.
Open "Method" dialog
to change settings.
Change instrument
face.
Exit the program.