Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 147)

147
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en COGO
Defining direction by magnetic bearing
If "Bearing" is selected in the
configuration for "Direc. Type:", then
the following dialog box appears: Northeast
Enter magnetic bearing
Offset
Enter parallel displacement.
Only active if "YES" is entered in the
configuration during "Offset:"
Left = negative parallel offset
Right = positive parallel offset
Accept displayed values and
proceed with dialog "Distance
to Traverse".
Determining the direction by
means of the function "Polar
calculation"( refer to chapter
"Inverse").
INPUT Enter quadrant,
magnetic bearing
RCALL Call up of a direction
which has been previously stored
using the function "Polar
calculation".
Quadrant
Enter quadrant:
1 = NorthEast
2 = SouthEast
3 = SouthWest
4 = NorthWest
Changing the direction
see under existing
dialog box "MODIFY BEARING"
Exit the program.
NorthEast
Display of entered magnetic bearings
Multiply
Entering multiplication factor
Divide
Entering division factor
COGO\ Traverse
Direction to Traverse
Quadrant : 1
NorthEast : 0°00’00’’
Offset : 0.000 m
CONT INV RCALL
MC
MODIF QUIT
COGO\ Modify Bearing
NorthEast : 0°00’00’’
Multiply : -----
Divide : -----
Add : 0°00’00’’
Subtract : 0°00’00’’
Northeast : 0°00’00’’
CONT
MC