Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 13)

13
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Orientation and Height Transfer
Displays the previous point
from the list of points entered.
Note that this key will not be available
until there is at least one point in the
list.
Displays the next point in the
list of points entered. Note
that this key will not be available until
there is at least one point in the list.
Search and display the
coordinates of the point found
in the active data job.
Run the calculation.
Note, the
key will be
assigned after the first measurement.
Start the
"CONFIGURATION"
Point List
Enter a maximum of 10 points. The
same point can be retrieved several
times.
Return to the dialog "Target
Point".
Measure Mode
This dialog is similar to the TPS
1000’s basic "Measure Mode" dialog.
Once a measurement is taken, the
program will return to the dialog
"Target Point" to acquire the next
point for measuring.
If the orientation correction can be
calculated successfully from any of
the first measurements, the
∆
Hz and
∆
V values are displayed for further
entered target point. Motorized
theodolites will automatically drive the
telescope to the target point.
Target Point, continued
Ori\ Point List
Point 1 : 1
Point 2 : 2
Point 3 : 3
Point 4 : 4
Point 5 : 5
Point 6 : 6
MC
QUIT
Point 7 : 7
Point 8 : 8
Point 9 : 9
Point 10 : 0
CONT