Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 200)

200
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Road+
Program Overview
"ROAD+" allows measurements in
one telescope position only. A typical
"ROAD+" session includes the
following steps:
1. Enter setup information for the
instrument and orient.
2. Start the ROAD+ program and
configure.
3. Select the alignment files
4. Select a station
5. Pick a point on the cross-section
to stakeout, enter an offset,
choose method.
6. Stake the point and record the
data.
7. Choose another point on the
cross-section and stake it out.
8. When all selected points on the
cross section have been staked,
enter a new station and repeat
steps 5-7.
In the sections that follow, operation
of the program will be covered in
more detail. This will assist you to
become proficient with the "ROAD+"
program for normal everyday
operations, such as staking a project
with stations and offsets, and slope
staking.
Getting started
Before starting the program, enter
the setup information for the location
of the theodolite and orient the
instrument to the reference point.
From the "MAIN MENU:
PROGRAMS" display, move the
highlighted cursor to the "ROAD+"
program and press on the
keyboard of the instrument. This will
bring up the "Select Aln Files" dialog.
The display illustration
examples contain text and
values for example purposes only.
The actual values you will see on the
display of your instrument will be
different.