Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 99)

99
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Sets of Angles
Set No.
Displays the number of the set
currently being measured. Always "1"
in the learning phase.
Seq. No.
Displays the sequential number of
the point currently being measured.
Face
Displays the required instrument face
for this measurement.
Point Id
Input the Point Id of the point
currently being measured.
Refl. Ht.
(Optional, but necessary for the
program to correctly calculate the
elevation of the target point.) Input
the Reflector Height of the point
currently being measured.
Auto Meas.
Automatic Measurement option,
available only with motorized
instruments. Select ON or OFF as
desired.
If OFF, motorized instruments must
be manually pointed to this
target point in further sets.
If ON, motorized instruments will
automatically turn toward this
target point in further sets.
If ON and the target is a prism,
motorized instruments with
ATR will automatically turn
toward, fine point and
measure to this target point.
Measure Mode, continued
Prism Type
(Optional, but necessary for the
instrument to correctly measure the
distance to the target point.) Select
the type of prism at this target point.
PrismConst
Display only of the offset of the
current Prism Type. Will be updated
if the Prism Type is changed.
Press after all settings are
correct and go to the
Measurement Dialog.
(Optional) Press to create a
list of up to ten target points.
Subsequent measurements may then
be made by selecting the target point
from this list.